LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Mirai XLE >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Panels / Trim - Service Information (1 Of 3) >> Rear Bumper >> Removal [11/2021 - 12/2023] >> Procedure

Removal [11/2021 - 12/2023]: Procedure

  1. REMOVE REAR COMBINATION LIGHT COVER LH 
    1. GTY1015691Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place hands here Remove in this Direction (1)
      Remove in this Direction (2) - -
      1. Put protective tape around the rear combination light cover LH.
      2. Detach the clip and remove the rear combination light cover LH.
  2. REMOVE REAR COMBINATION LIGHT COVER RH 
    GTY993405Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    		 Use the same procedure described for the LH side.
  3. REMOVE REAR BUMPER ASSEMBLY 
    1. GTY1014983Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Clip Screw
      1. Remove the 10 clips.
      2. Remove the 2 screws.
    2. GTY1015721Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Screw Clip
      Grommet - -
      1. Put protective tape around the rear bumper assembly.
      2. Remove the clip and 2 grommets.
      3. Using a screwdriver, detach the claw as shown in the illustration.

        HINT: 

        Tape the screwdriver tip before use.

      4. Fold back the rear wheel house liner LH and remove the screw.
      5. Detach the claw.
    3. Use the same procedure for the other side.
    4. GTY1016205Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A w/ Advanced Drive - -
      Connector Screw
      1. w/ Advanced Drive:

        1. Detach the claw and disconnect the LiDAR cleaner hose.

        HINT: 

        Prepare a container before performing the procedure.

      2. Remove the 2 screws.
      3. Detach the claw and remove the rear bumper assembly.
      4. Disconnect each connector.
scientia non olet · About LEMON Manuals