Inspection [11/2020 - ]: Procedure
- INSPECT FUEL LID OPENER SWITCH
- Check the operation of the Fuel lid opener switch.
*a Component without harness connected
(Fuel Lid Opener Switch)- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Switch Condition Specified Condition Result D113-2(E) - D113-5(IG) Fuel lid opener switch pushed (ON) Below 1 Ω Ω D113-2(E) - D113-5(IG) Fuel lid opener switch not pushed (OFF) 10 kΩ or higher kΩ
- Measure the resistance according to the value(s) in the table below.
- Check the operation of the Fuel lid opener switch.