Caution / Notice / Hint

NOTE:

If the vehicle speed is outside the allowable range when tested, perform the operation check.
Refer to OPERATION CHECK [11/2020 - ]
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2020 - 11/2021] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - 12/2022] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2022 - 12/2023]

HINT:

Before starting the following inspection, check tire size and tire air pressure.