Hazard Warning Switch Circuit [11/2020 - 12/2023]: Procedure

1. Read the Data List according to the display on the GTS.

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Hazard Flasher Switch	Hazard warning signal switch signal	OFF or ON	OFF: Hazard warning signal switch off ON: Hazard warning signal switch on	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   Hazard Flasher Switch

   OK

   Normal conditions listed above are displayed.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [11/2020 - 12/2023] 

Result: 

NG 

See step  2

Refer to INSPECTION [11/2020 - 11/2021] , or refer to INSPECTION [11/2021 - ]

Result

Result: 

NG 

REPLACE HAZARD WARNING SIGNAL SWITCH ASSEMBLY. Refer to  REMOVAL [11/2020 - 12/2022]  , or refer to  REMOVAL [12/2022 - 12/2023] 

Result: 

OK 

See step  3

1. Disconnect the D99 hazard warning signal switch assembly connector.
2. Disconnect the D42 combination meter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D99-5 (TB) - D42-2 (HAZ)	Always	Below 1 Ω
   D99-5 (TB) or D42-2 (HAZ) - Body ground	Always	10 kΩ or higher
   D99-4 (E) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [11/2020 - 11/2021]  , or refer to  REMOVAL [11/2021 - 12/2022]  , or refer to  REMOVAL [12/2022 - 12/2023] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR