Caution / Notice / Hint

NOTE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed.
Refer to PRECAUTION [12/2023 - ]
When replacing the combination meter assembly, replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in the combination meter assembly will not match the information from the vehicle and a DTC may be stored.
When replacing the combination meter assembly, make sure to update the ECU security key.
Refer to UPDATE ECU SECURITY KEY [11/2020 - ]

HINT:

Before disconnecting the connectors for inspection, push each connector in the connection direction and check that it is not loose or disconnected.
After disconnecting the connector, check that the connector and terminals are not damaged, deformed or corroded.