Center Airbag Sensor Communication Stop Mode [11/2020 - 12/2022]: Procedure

1. Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.
2. Disconnect the D10 airbag ECU assembly connector.

   Refer to PRECAUTION [11/2020 - 12/2022]

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D10-26 (CAFH) - D10-27 (CAFL)	Cable disconnected from negative (-) auxiliary battery terminal	54 to 69 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE CAN BRANCH WIRE OR CONNECTOR 

Result: 

OK 

See step  2

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D10-32 (E2) - Body ground	Cable disconnected from negative (-) auxiliary battery terminal	Below 1 Ω
   D10-33 (E1) - Body ground	Cable disconnected from negative (-) auxiliary battery terminal	Below 1 Ω

2. Reconnect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.
3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   D10-36 (IG2) - Body ground	Ignition switch ON	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE AIRBAG ECU ASSEMBLY. Refer to  REMOVAL [11/2020 - 11/2021]  , or refer to  REMOVAL [11/2021 - 12/2022] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)