Confirmation Driving Pattern

HINT: 

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Refer to UTILITY [11/2020 - ]

1. Turn the ignition switch to ON (READY) and wait for 5 seconds or more.
2. Drive the vehicle for approximately 10 minutes.
3. Enter the following menus: Powertrain / EV / Utility / All Readiness.
4. Check the DTC judgment result.

   HINT: 

   • If the judgment result shows NORMAL, the system is normal.
   • If the judgment result shows ABNORMAL, the system has a malfunction.
   • If the judgment result shows INCOMPLETE, perform driving pattern again.