Confirmation Driving Pattern

HINT: 

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Refer to UTILITY [11/2020 - ]

1. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
2. Turn the ignition switch off and wait for 10 minutes or more.
3. Turn the ignition switch to ON (READY).
4. Enter the following menus: Powertrain / EV Battery / Active Test / Control the Hybrid/EV Battery Cooling Fan.
5. Operate the battery cooling blower assembly in each fan mode, 1 through 6, for 60 seconds or more.

   HINT: 

   Operation of the battery cooling blower assembly can be confirmed by checking if air is sucked into the air intake port of the intake duct.

6. Enter the following menus: Powertrain / EV Battery / Utility / All Readiness.
7. Check the DTC judgment result.

   HINT: 

   • If the judgment result shows NORMAL, the system is normal.
   • If the judgment result shows ABNORMAL, the system has a malfunction.
   • If the judgment result shows INCOMPLETE, perform driving pattern again.