Caution / Notice / Hint

NOTE:

Before replacing the main body ECU (multiplex network body ECU), refer to Registration.
w/ Front LiDAR Sensor: Refer to REGISTRATION [12/2023 - ]

w/o Front LiDAR Sensor: Refer to REGISTRATION [12/2023 - ]
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.
w/ Front LiDAR Sensor: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2023 - ]

w/o Front LiDAR Sensor: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2023 - ]

HINT:

The meter illumination dims when the taillights are turned on.
Setting the meter illumination level to maximum brightness cancels the above dimming of the meter illumination.
Setting the meter illumination level to minimum brightness turns off the meter illumination.
The automatic light control sensor sensitivity can be customized.
for Stereo Camera Type: Refer to CUSTOMIZE PARAMETERS [12/2023 - ]

for Mono Camera Type: Refer to CUSTOMIZE PARAMETERS [12/2023 - ]