DTC B1510-87: Lost Communication with HUD Gigabit Video Interface Missing Message [11/2021 - 12/2023]: Procedure

1. Check for DTCs and the output pattern according to the following table.

   Body Electrical > Combination Meter > Trouble Codes 

2. Check for DTCs and the output pattern according to the following table.

   Body Electrical > Head Up Display > Trouble Codes 

   Pattern	DTC Output Part Name
   	Combination Meter Assembly	Head Up Display
   	B1510-87	B1511-87
   Pattern 1	◦	◦
   Pattern 2	◦	-

   ◦: DTC is output.-: DTC is not output

   Result

   Result	Proceed to
   Pattern 1	A
   Pattern 2	B

Result: 

B 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [11/2021 - 12/2022]  , or refer to  REMOVAL [12/2022 - 12/2023] 

Result: 

A 

See step  2

Pre-procedure1

1. Disconnect the combination meter assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to Combination Meter Assembly)
   *b	Front view of wire harness connector (to Meter Mirror Sub-assembly)

2. Disconnect the meter mirror sub-assembly connector.

   Procedure1

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D157-2 (MGV-) - D156-1 (HGV-)	Always	Below 1 Ω
   D157-1 (MGV+) - D156-2 (HGV+)	Always	Below 1 Ω
   D157-3 (MGVG) - D156-3 (HGVG)	Always	Below 1 Ω
   D157-2 (MGV-) or D156-1 (MGV-) - Body ground	Always	10 kΩ or higher
   D157-1 (MGV+) or D156-2 (MGV+) - Body ground	Always	10 kΩ or higher
   D157-3 (MGVG) or D156-3 (MGVG) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

   Post-procedure1

4. None

Result: 

NG 

REPAIR OR REPLACE CAN MAIN WIRE OR CONNECTOR 

Result: 

OK 

See step  3

1. Replace the meter mirror sub-assembly with a new one.

   Refer to REMOVAL [11/2021 - 12/2022] , or refer to REMOVAL [12/2022 - 12/2023]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Clear the DTCs.

   Body Electrical > Combination Meter > Trouble Codes 

2. Recheck for DTCs and check that no DTCs are output.

   Body Electrical > Combination Meter > Trouble Codes 

   OK

   No DTCs are output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (METER MIRROR SUB-ASSEMBLY IS DEFECTIVE) 

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [11/2021 - 12/2022]  , or refer to  REMOVAL [12/2022 - 12/2023]