DTC C1380-7F: Stop Lamp Relay Actuator Stuck Off [12/2023 - ]: Description
Refer to DTC C1380-7E.
Refer to DTC C1380-7E: Stop Lamp Relay Actuator Stuck On [12/2023 - ]
| DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
DTC Output from |
Priority |
Note |
| C1380-7F |
Stop Lamp Relay Actuator Stuck Off |
w/ Front LiDAR Sensor:
Either of the following is detected:
- When the IG1 terminal voltage exceeds 10 V and the +BS terminal voltage is from 9.5 to 17.4 V, stop light drive output (STPO) is ON, STP is OFF and STP2 is OFF continuously for 2 seconds or more.
- When the IG1 terminal voltage exceeds 10 V and the +BS terminal voltage is from 9.5 to 17.4 V, STP2 is OFF and STP is ON continuously for 5 seconds or more.
w/o Front LiDAR Sensor:
Either of the following is detected:
- When the IG1 terminal voltage exceeds 10 V and the +BS terminal voltage is from 9.5 to 17.4 V, stop light drive output (STPO) is ON, STP is OFF and STP2 is OFF continuously for 2 seconds or more.
- When the IG1 terminal voltage exceeds 10 V and the +BS terminal voltage is from 9.5 to 17.4 V, STP is OFF and STP2 is ON continuously for 5 seconds or more.
|
- Wire harness and connector
- Stop light switch assembly
- No. 2 skid control ECU (brake actuator assembly)
- No. 2 semiconductor power integration ECU*
- STP circuit
- STP2 circuit
|
Brake/EPB |
B |
Output ECU: No. 2 skid control ECU (brake actuator assembly) |
*: w/ Front LiDAR Sensor