DTC C136F-00: Non-learning of the Braking System information. [11/2020 - ]: Description
The No. 1 skid control ECU (brake booster with master cylinder assembly) stores identification information sent from other ECUs when the vehicle is shipped from the factory and changes the control constant for each system (ABS, VSC, TRC, etc.) based on the identification information.
NOTE:
DTC C136F-00 is output when an incorrect ECU is installed. If initialization is performed and learning occurs with an incorrect ECU installed, operations and functions will differ from those stored when the vehicle was shipped from the factory. Therefore, make sure that learning occurs properly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|
| C136F-00 | Non-learning of the Braking System information. | Either of the following is detected:
|
|
Brake Booster | A | Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) HINT: The DTC is cleared when the conditions return to normal. |
C136F-00 DTC DETECTION CONDITIONS
| Vehicle Condition | ||||
|---|---|---|---|---|
| Pattern 1 | Pattern 2 | Pattern 3 | ||
| Diagnosis Condition | - | - | - | - |
| Malfunction Status | The drive system information sent from the EV control ECU does not match the information stored in the No. 1 skid control ECU (brake booster with master cylinder assembly) | ◦ | - | - |
| No system information stored in the No. 1 skid control ECU (brake booster with master cylinder assembly) | - | ◦ | - | |
| The steering wheel judgment information sent from the main body ECU (multiplex network body ECU) does not match the information stored in the No. 1 skid control ECU (brake booster with master cylinder assembly) | - | - | ◦ | |
| Detection Time | - | - | ||
| Number of Trips | 1 trip | 1 trip | 1 trip | |
HINT:
DTC will be output when conditions for either of the patterns in the table above are met.