Caution / Notice / Hint

COMPONENTS (REMOVAL)

Fig 1: Windshield Outside Moulding Removal Components [12/2023 - ]

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Procedure		Part Name Code	Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1	LOWER WINDSHIELD MOULDING OUTSIDE LH	75536D	See step 1	-	-
2	NO. 1 WINDSHIELD OUTSIDE MOULDING CLIP	75545B	-	-	-
3	WINDSHIELD GLASS	56111	See step 3	-	-
4	NO. 3 WINDSHIELD OUTSIDE MOULDING CLIP	75547C	See step 4	-	-

•

Non-reusable part

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the No. 3 windshield outside moulding clip removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedures	Necessary Procedures	Effect/Inoperative Function when Necessary Procedures are not Performed	Link
for Stereo Camera Type: Windshield glass (Including removal and installation)	Adjust object recognition camera	Dynamic radar cruise control system (for Stereo camera type) Front camera system (for Stereo camera type) Lane tracing assist system (for Stereo camera type) Road sign assist system (for Stereo camera type) Pre-collision system (for Stereo camera type) Automatic high beam system	One Time Recognition: Refer to ADJUSTMENT (ONE TIME RECOGNITION) [12/2023 - ] Sequential Recognition: Refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [12/2023 - ]
for Mono Camera Type: Windshield glass*	Adjust forward recognition camera	Front camera system (for Mono Camera Type) Traffic jam assist system Autumatic High Beam System	for Target Adjustment (One Time Recognition): Refer to TARGET ADJUSTMENT (ONE TIME RECOGNITION) [12/2023 - ] for Driving Adjustment: Refer to DRIVING ADJUSTMENT [12/2023 - ]

*: w/ SXM System

HINT:

Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.