Removal [11/2020 - 11/2021]: Procedure

REMOVE LOWER WINDSHIELD MOULDING OUTSIDE LH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Put protective tape around the lower windshield moulding outside LH.
Detach the claw and remove the lower windshield moulding outside LH.

REMOVE NO. 1 WINDSHIELD OUTSIDE MOULDING CLIP

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE WINDSHIELD GLASS

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:
Perform the following procedure only when replacement of the No. 3 windshield outside moulding clip is necessary.
Refer to REMOVAL [11/2020 - 11/2021]

REMOVE NO. 3 WINDSHIELD OUTSIDE MOULDING CLIP

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:
Perform the following procedure only when replacement of the No. 3 windshield outside moulding clip is necessary.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Tape

Flange

Insert a 4.0 mm (0.157 in.) drill bit into a drill.

Tape the 4.0 mm (0.157 in.) drill bit 5.0 mm (0.197 in.) from the tip as shown in the illustration.

Standard Measurement

Area	Measurement	Area	Measurement
A	5.0 mm (0.197 in.)	-	-

NOTE:

Tape the 4.0 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.

Lightly press the drill against the No. 3 windshield outside moulding clips to drill off the No. 3 windshield outside moulding clip flanges, and remove the 5 No. 3 windshield outside moulding clips.
WARNING:
Be careful of the drilled No. 3 windshield outside moulding clips, as they may be hot.
NOTE:
- Pressing the drill too firmly will cause the No. 3 windshield outside moulding clip to turn and result in the No. 3 windshield outside moulding clip not being drilled through.
- Prying the No. 3 windshield outside moulding clips with the drill may damage the No. 3 windshield outside moulding clip installation holes or drill bit.