LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Mirai Limited >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Panels / Trim - Service Information (2 Of 3) >> Rear Door Belt Moulding >> Removal [12/2022 - 12/2023] >> Procedure

Removal [12/2022 - 12/2023]: Procedure

  1. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to REMOVAL [12/2022 - 12/2023]

  2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH 
    GTY993405Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    		 Refer to PROCEDURE - Step 3
  3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL 
    GTY993405Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    		 Refer to PROCEDURE - Step 4
  4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH 
    GTY993405Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    		 Refer to PROCEDURE - Step 5
  5. REMOVE REAR DOOR GLASS INNER WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 10

  6. REMOVE REAR DOOR BELT REAR SEAL LH 
    GTY993405Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    		 Refer to PROCEDURE - Step 12
  7. REMOVE REAR DOOR ARMREST SET BRACKET LH 

    Refer to PROCEDURE - Step 14

  8. REMOVE REAR DOOR SERVICE HOLE COVER LH 
    GTY993405Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    		 Refer to PROCEDURE - Step 15
  9. REMOVE REAR DOOR GLASS RUN LH 

    Refer to PROCEDURE - Step 17

  10. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 18

  11. REMOVE REAR DOOR QUARTER WINDOW GLASS LH 

    Refer to PROCEDURE - Step 19

  12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH 
    GTY993405Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    		 Refer to PROCEDURE - Step 21
  13. REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH 
    1. GTY1015085Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction Push in this Direction
      1. Put protective tape around the rear door belt moulding assembly LH.
      2. Detach the claw and remove the rear door belt moulding assembly LH as shown in the illustration.
scientia non olet · About LEMON Manuals