Inspection [11/2020 - ]: Procedure

INSPECT SEAT MEMORY SWITCH LH

Check the resistance.

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Condition	Specified Condition	Result
E28-2 (MMRY) - E28-1 (E)	SET switch pressed	Below 1 Ω	Ω
E28-2 (MMRY) - E28-1 (E)	SET switch not pressed	10 kΩ or higher	kΩ
E28-3 (1) - E28-1 (E)	1 switch pressed	Below 1 Ω	Ω
E28-3 (1) - E28-1 (E)	1 switch not pressed	10 kΩ or higher	kΩ
E28-4 (2) - E28-1 (E)	2 switch pressed	Below 1 Ω	Ω
E28-4 (2) - E28-1 (E)	2 switch not pressed	10 kΩ or higher	kΩ

*a	Component without harness connected (Seat Memory Switch LH)

If the result is not as specified, replace the seat memory switch LH.