Seat Heater for Rear Right Seat does not Operate [12/2023 - ]: Procedure
- PERFORM ACTIVE TEST USING GTS (SEAT HEATER)
- Perform the Active Test according to the display on the GTS.
- w/ Front LiDAR Sensor:
Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note Rear Right Seat Heater Rear right side seat heater operation OFF/ON - Body Electrical > Air Conditioner > Active Test
Tester Display Rear Right Seat Heater - w/o Front LiDAR Sensor:
Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note Rear Right Seat Heater Rear right side seat heater operation OFF/ON - Body Electrical > Air Conditioner > Active Test
Tester Display Rear Right Seat Heater
OK
Rear right side seat heater operates normally.
Result
Proceed to OK NG - w/ Front LiDAR Sensor:
Result:
NG
See step 4
Result:
OK
See step 2
- Perform the Active Test according to the display on the GTS.
- REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY
- Replace the air conditioner amplifier assembly with a new one or known good one.
Refer to REMOVAL [11/2020 - ]
Result
Proceed to OK
Result:
OK
See step 3
- Replace the air conditioner amplifier assembly with a new one or known good one.
- CHECK REAR SEAT HEATER OPERATION
- Check the rear right side seat heater operation.
Refer to OPERATION CHECK [11/2020 - ]
OK
Rear right side seat heater operates normally.
Result
Proceed to OK NG
Result:
OK
END (AIR CONDITIONING AMPLIFIER ASSEMBLY WAS DEFECTIVE)
Result:
NG
REPLACE COOLER CONTROL SWITCH ASSEMBLY. Refer to REMOVAL [11/2020 - ]
- Check the rear right side seat heater operation.
- CHECK HARNESS AND CONNECTOR (SEAT HEATER CONTROL SUB-ASSEMBLY (REAR SEAT RH) POWER SOURCE CIRCUIT)
- Disconnect the M5 seat heater control sub-assembly (rear seat RH) connector.
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Switch Condition Specified Condition M5-1 (+B1) - Body ground Ignition switch ON 11 to 14 V M5-1 (+B1) - Body ground Ignition switch off Below 1 V Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 5
- CHECK HARNESS AND CONNECTOR (AIR CONDITIONER AMPLIFIER ASSEMBLY - SEAT HEATER CONTROL SUB-ASSEMBLY [REAR SEAT RH])
- Disconnect the D79 air conditioning amplifier assembly connector.
- Disconnect the M5 seat heater control sub-assembly (rear seat RH) connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition D79-23 (SM2R) - M5-5 (SWR) Always Below 1 Ω D79-23 (SM2R) or M5-5 (SWR) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 6
- CHECK HARNESS AND CONNECTOR (SEATBACK HEATER ASSEMBLY LH - SEAT HEATER CONTROL SUB-ASSEMBLY (REAR SEAT RH))
- Disconnect the M6 seatback heater assembly RH connector.
- Disconnect the M5 seat heater control sub-assembly (rear seat RH) connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition M6-4 - M5-10(E) Always Below 1 Ω M6-1 - M5-7(HTR1) Always Below 1 Ω M6-4 or M5-10 (E) - Body ground Always 10 kΩ or higher M6-1 or M5-7(HTR1) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 7
- CHECK HARNESS AND CONNECTOR (SEATBACK HEATER ASSEMBLY RH - BODY GROUND)
- Disconnect the M6 seatback heater assembly RH connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition M6-5 - Body ground Always Below 1 Ω M6-5 - Other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 8
- INSPECT SEATBACK HEATER ASSEMBLY RH
Refer to INSPECTION [11/2020 - ]
Result
Proceed to OK NG Result:
NG
REPLACE SEATBACK HEATER ASSEMBLY RH. Refer to REMOVAL [11/2020 - ]
Result:
OK
See step 9
- INSPECT SEAT CUSHION HEATER ASSEMBLY RH
Refer to INSPECTION [11/2020 - ]
Result
Proceed to OK NG Result:
NG
REPLACE SEAT CUSHION HEATER ASSEMBLY RH. Refer to REMOVAL [11/2020 - ]
Result:
OK
See step 10
- REPLACE SEAT HEATER CONTROL SUB-ASSEMBLY (REAR SEAT RH)
- Replace the seat heater control sub-assembly (rear seat RH) with a new one or known good one.
Refer to REMOVAL [11/2020 - ]
Result
Proceed to OK
Result:
OK
See step 11
- Replace the seat heater control sub-assembly (rear seat RH) with a new one or known good one.
- CHECK REAR SEAT HEATER OPERATION
- Check the rear right side seat heater operation.
Refer to OPERATION CHECK [11/2020 - ]
OK
Rear right side seat heater operates normally.
Result
Proceed to OK NG
Result:
OK
END (SEAT HEATER CONTROL SUB-ASSEMBLY (REAR SEAT RH) WAS DEFECTIVE)
Result:
NG
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY. Refer to REMOVAL [11/2020 - ]
- Check the rear right side seat heater operation.