Rear Sunshade Shift-linked Function does not Operate when Shift Lever is Moved to R Position [11/2020 - 12/2023]: Procedure

1. Using the GTS, perform the Active Test.

   Refer to DATA LIST / ACTIVE TEST [11/2020 - 12/2023] 

   Body Electrical > Main Body > Active Test 

   Tester Display	Measurement Item	Control Range	Diagnostic Note
   Reverse Gear Signal	Reverse signal	ON / OFF	-

   Body Electrical > Main Body > Active Test 

   Tester Display
   Reverse Gear Signal

   HINT: 

   Perform the Active Test while the rear sunshade is fully raised or a raise operation is in progress.

   OK

   Rear sunshade can be lowered.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [11/2020 - 11/2021]  , or refer to  REMOVAL [11/2021 - 12/2022]  , or refer to  REMOVAL [12/2022 - 12/2023] 

Result: 

NG 

See step  2

1. Disconnect the G16 rear window shade assembly connector.
2. Disconnect the D12 main body ECU (multiplex network body ECU) connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G16-3 (REV) - D12-6 (REV)	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  3

1. Disconnect the D12 main body ECU (multiplex network body ECU) connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   D12-6 (REV) - Body ground	Start the hybrid control system, shift lever in not R	11 to 14 V
   	Start the hybrid control system, shift lever in R	Below 1 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [11/2020 - 11/2021]  , or refer to  REMOVAL [11/2021 - 12/2022]  , or refer to  REMOVAL [12/2022 - 12/2023] 

Result: 

NG 

REPLACE REAR WINDOW SHADE ASSEMBLY. Refer to  REMOVAL [11/2020 - ]