LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Land Cruiser Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Service Information >> Shift Lever >> On-Vehicle Inspection [08/2015 - ] >> Procedure

On-Vehicle Inspection [08/2015 - ]: Procedure

  1. INSPECT SHIFT LEVER POSITION 
    1. When moving the shift lever from P to R with the engine switch on (IG) and the brake pedal depressed, make sure that it moves smoothly and correctly into position.
    2. Check that the shift lever does not stop when moving the shift lever from R to P, and check that the shift lever does not stick when moving the shift lever from D to S.
    3. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves rearward after moving the shift lever to R.

      If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.

  2. CHECK SHIFT LOCK OPERATION 
    1. Move the shift lever to P.
    2. Turn the engine switch off.
    3. Check that the shift lever cannot be moved from P.
    4. Turn the engine switch on (IG), depress the brake pedal and check that the shift lever can be moved to other positions.

      If the operation cannot be done as specified, inspect the shift lever assembly and shift lock control ECU subassembly.

  3. CHECK SHIFT LOCK RELEASE BUTTON OPERATION 
    1. When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position.

      If the operation cannot be performed as specified, check the shift lever assembly.

  4. CHECK SHIFT LOCK CONTROL ECU SUBASSEMBLY 
    1. Measure the voltage according to the value(s) in the table below.
      GTY570834Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Voltage

      Tester Connection Condition Specified Condition
      12 (IG) - 3 (E) Engine switch on (IG) 11 to 14 V
      Engine switch off Below 1 V
      6 (STP) - 3 (E) Brake pedal depressed 11 to 14 V
      Brake pedal released Below 1 V
      TEXT IN ILLUSTRATION

      *a Component with harness connected
      (Shift Lock Control ECU)

      HINT: 

      Do not disconnect the shift lock control ECU connector.

    2. Measure the resistance according to the value(s) in the table below.
      GTY570835Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Value
      3 (E) - Body ground Always Below 1 Ω
      TEXT IN ILLUSTRATION

      *a Component with harness connected
      (Shift Lock Control ECU)

      HINT: 

      Do not disconnect the shift lock control ECU connector.

    3. Disconnect the shift lock solenoid connector from the shift lock control ECU subassembly.
    4. Measure the voltage according to the value(s) in the table below.
      GTY564460Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Voltage

      Tester Connection Condition Specified Condition
      1 (SLS+) - 2 (SLS-) Engine switch off Below 1 V
      1 (SLS+) - 2 (SLS-) Engine switch on (IG) Below 1 V
      Engine switch on (IG) and brake pedal depressed 11 to 14 V
      TEXT IN ILLUSTRATION

      *a Component with harness connected
      (Shift Lock Control ECU)

      HINT: 

      Do not disconnect the shift lock control ECU connector.

      If the result is not as specified, replace the shift lever assembly.

scientia non olet · About LEMON Manuals