Entire Combination Meter does not Operate [08/2015 - ]: Procedure

1. Remove the METER and MPX-B NO. 2 fuses from the engine room relay block.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   METER fuse	Always	Below 1 Ω
   MPX-B NO. 2 fuse

Result: 

NG 

REPLACE FUSE 

Result: 

OK 

See step  2

1. Disconnect the E99 Combination meter assembly connector.
2. Measure the resistance and voltage according to the value(s) in the tables below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E99-20 (ET) - Body ground	Always	Below 1 Ω

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   E99-21 (B) - Body ground	Always	11 to 14 V
   E99-22 (IG+) - Body ground	Engine switch on (IG)

   TEXT IN ILLUSTRATION
   
   

   *a	Component without harness connected (Combination Meter Assembly)

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY 

(Refer to REMOVAL [08/2015 - ] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR