DTC U0129: Lost Communication with Brake System Control Module [08/2015 - ]: Procedure

1. Check for DTCs and note any codes that are output (Refer to DTC CHECK / CLEAR [08/2015 - ] ).
2. Clear the DTCs (Refer to DTC CHECK / CLEAR [08/2015 - ] ).
3. Recheck for DTCs (Refer to DTC CHECK / CLEAR [08/2015 - ] ).
   RESULT
   
   

   Result	Proceed to
   CAN communication system DTC is not output	A
   CAN communication system DTC is output	B

   HINT: 

   If CAN communication system DTC U0129 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0129 first.

Result: 

A 

USE SIMULATION METHOD TO CHECK 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2017] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2017 - ] )

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] )