LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Highlander XSE, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 380 (Electric Parking Brake System (Except HEV) - Diagnostic Codes, Symptom Tests & Circuit Tests) >> ELECTRIC PARKING BRAKE SYSTEM (for Gasoline Model) >> DTC C060B-12: Left Electric Parking Brake Actuator Control Circuit Short to Battery [11/2022 - ] >> Procedure

DTC C060B-12: Left Electric Parking Brake Actuator Control Circuit Short to Battery [11/2022 - ]: Procedure

WARNING: This page is about a different car, the 2025 Toyota Corolla Cross, 2024 Toyota Corolla Cross, and 2023 Toyota Corolla Cross. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR SHORT TO +B 
    1. Turn the ignition switch off.
    2. Make sure the No. 2 parking brake wire assembly is securely installed.
    3. Disconnect the n1 parking brake actuator assembly LH connector.
    4. Measure the voltage according to the value(s) in the table below.
      GTY1035055Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of No. 2 Parking Brake Wire Assembly
      (to Parking Brake Actuator Assembly LH)

      Standard Voltage

      Tester Connection Condition Specified Condition
      n1-2 (MRL+) - n1-1 (MRL-) Electric parking brake not operating Below 1 V

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE PARKING BRAKE ACTUATOR ASSEMBLY LH. Refer to  REMOVAL [11/2022 - ] 

    Result: 

    NG 

    See step  2

  2. CHECK FOR SHORT TO +B 
    1. Disconnect the nO3 No. 2 parking brake wire assembly connector.
    2. Measure the voltage according to the value(s) in the table below.
      GTY881737Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to No. 2 Parking Brake Wire Assembly)

      Standard Voltage

      Tester Connection Condition Specified Condition
      nO3-1 - nO3-2 Electric parking brake not operating Below 1 V

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE NO. 2 PARKING BRAKE WIRE ASSEMBLY 

    Result: 

    NG 

    See step  3

  3. CHECK FOR SHORT TO +B 
    1. Disconnect the nO3 No. 2 parking brake wire assembly connector.
    2. Disconnect the A151 skid control ECU (brake actuator assembly) connector.
    3. Measure the voltage according to the value(s) in the table below.
      GTY1033431Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector *b (to Skid Control ECU (Brake Actuator Assembly))
      *c (to No. 2 Parking Brake Wire Assembly) - -

      Standard Voltage

      Tester Connection Condition Specified Condition
      nO3-1 or A151-13 (MRL+) - Body ground Always Below 1 V
      nO3-2 or A151-12 (MRL-) - Body ground Always Below 1 V

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY). Refer to  REMOVAL [11/2022 - ] 

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

scientia non olet · About LEMON Manuals