Typical Enabling Conditions
WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
| All of the following conditions are met | - |
| Ignition switch | Off |
| Engine | Stall |
| Soak time | 6, 6.5 and 7 hours |
| One of the following conditions is met | (a) or (b) |
| (a) Engine control module internal temperature | -10°C (14°F) or higher |
| (b) Intake air temperature | -10°C (14°F) or higher |
| Engine control module internal temperature sensor circuit fail (P06AD, P06AE) | Not detected |
| Intake air temperature sensor circuit fail (P0112, P0113) | Not detected |
| Soak timer fail (P2610) | Not detected |
| Battery voltage | 8 V or higher |
| Starter | Off |
| Time after ECM power on | 0.5 seconds or more |