DTC P111C-62: Control Module Internal Temperature Sensor/Intake Air Temperature Sensor Signal Compare Failure [10/2022 - ]: Procedure
WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO P111C-62)
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P111C-62 is output A DTC P111C-62 and other DTCs are output B HINT:
If any DTCs other than P111C-62 are output, troubleshoot those DTCs first.
- Record the Freeze Frame Data.
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2022 - 11/2023] , or refer to DIAGNOSTIC TROUBLE CODE CHART [11/2023 - ]
Result:
A
See step 2
- Read the DTCs.
- CHECK FREEZE FRAME DATA (INTAKE AIR TEMPERATURE AND AMBIENT TEMPERATURE)
- Using the GTS, read the values displayed in the Freeze Frame Data recorded in step 1.
Powertrain > Engine > DTC (P111C-62) > Freeze Frame Data
Tester Display Intake Air Temperature Ambient Temperature - Read the value displayed on the GTS.
Standard
Difference between the Intake Air Temperature and the Ambient Temperature is within 15°C (27°F).
HINT:
- When the engine is cold, the value of the intake air temperature, ECM internal temperature and ambient temperature should be approximately the same.
- Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.
Refer to INITIALIZATION [10/2022 - ]
Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [10/2022 - 11/2023] , or refer to REMOVAL [11/2023 - ]
Result:
NG
REPLACE MASS AIR FLOW METER SUB-ASSEMBLY. Refer to REMOVAL [10/2022 - ]
- Using the GTS, read the values displayed in the Freeze Frame Data recorded in step 1.