DTC P0340-31: Camshaft Position Sensor "A" Bank 1 or Single Sensor No Signal [10/2022 - ]: Description
WARNING: This page is about a different car, the 2025 Toyota Highlander, 2024 Toyota Highlander, and 2023 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
Refer to DTC P0340-11.
Refer to DESCRIPTION
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Note |
|---|---|---|---|---|---|
| P0340-31 | Camshaft Position Sensor "A" Bank 1 or Single Sensor No Signal | No camshaft position sensor (for intake camshaft) signal for 5 seconds at an engine speed of 600 rpm or higher (1 trip detection logic). * |
|
Comes on | SAE Code: P0340 |
- *: When the engine is being stopped or started automatically by stop and start system control, the ECM does not monitor the camshaft position sensor signal. (w/ stop and start system)
Reference: Inspection using an oscilloscope.
Refer to DESCRIPTION