Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear suspension arm assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Rear wheel alignment adjustment | for TMC Made
|
|
w/ Electric Parking Brake System: Refer to UTILITY [09/2022 - 11/2022] w/o Electric Parking Brake System: Refer to UTILITY [09/2022 - 09/2024] |
for TMMMS Made
|
|
w/ Electric Parking Brake System: Refer to UTILITY [09/2022 - 11/2022] w/o Electric Parking Brake System: Refer to UTILITY [09/2022 - 11/2022] |
|
| Tire | ECU Data Initialization (When performing tire replacement after RoB code X2104 is output) | Active Torque Split AWD System | Refer to CALIBRATION [09/2022 - ] |
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.