Removal [01/2019 - 06/2021]: Procedure

REMOVE REAR WHEEL
Refer to PROCEDURE - Step 1 [01/2019 - 03/2019] , or refer to REMOVAL [03/2019 - 09/2022]
REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Height Control Sensor)
1. for LH Side:
  Refer to REMOVAL [06/2018 - 09/2022]
REMOVE REAR FLOOR SIDE MEMBER COVER LH (w/ Cover)
1. for LH Side:
  for Hatchback: See step 2 [06/2018 - 09/2019], or refer to PROCEDURE - Step 2 [09/2019 - 09/2022]
  
  for Sedan: See step 2 [01/2019 - 09/2020], or see step 2 [09/2020 - 09/2022]
REMOVE REAR FLOOR SIDE MEMBER COVER RH (w/ Cover)
1. for RH Side:
  for Hatchback: See step 3 [06/2018 - 09/2019], or refer to PROCEDURE - Step 3 [09/2019 - 09/2022]
  
  for Sedan: See step 3 [01/2019 - 09/2020], or see step 3 [09/2020 - 09/2022]
REMOVE REAR STABILIZER LINK ASSEMBLY
for Hatchback: See step 4 [06/2018 - 09/2019], or refer to PROCEDURE - Step 4 [09/2019 - 09/2022]

for Sedan: See step 4 [01/2019 - 09/2020], or see step 4 [09/2020 - 09/2022]
REMOVE REAR COIL SPRING
Refer to PROCEDURE - Step 6
REMOVE REAR LOWER COIL SPRING INSULATOR
Refer to PROCEDURE - Step 8

REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY

Remove the nut, No. 2 camber adjust cam, rear suspension toe adjust cam sub-assembly and rear No. 2 suspension arm assembly.

NOTE:

Hold the rear suspension toe adjust cam sub-assembly while rotating the nut.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY

Remove the 2 bolts, 2 nuts and rear No. 1 suspension arm assembly from the rear axle carrier sub-assembly and rear suspension member sub-assembly.

NOTE:

Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.