Engine Oil Pressure Switch Circuit [01/2019 - 09/2022]: Procedure

1. Inspect the engine oil pressure switch assembly.

   Refer to INSPECTION [01/2019 - 11/2022]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE ENGINE OIL PRESSURE SWITCH ASSEMBLY. Refer to  REMOVAL [01/2019 - 11/2022] 

Result: 

OK 

See step  2

1. Disconnect the I5 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C39-1 - I5-23 (S)	Always	Below 1 Ω
   C39-1 or I5-23 (S) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [01/2019 - 03/2019]  , or refer to  REMOVAL [03/2019 - 09/2022] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR