LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Corolla LE >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake System (W/O Electric Parking Brake) - Inspection >> PARKING BRAKE SYSTEM (w/o Electric Parking Brake) >> Adjustment [11/2022 - ] >> Procedure

Adjustment [11/2022 - ]: Procedure

  1. INSPECT PARKING BRAKE LEVER TRAVEL 
    1. Firmly pull the parking brake lever.
    2. Release the parking brake lever lock and return it to its off position.
    3. Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.
      GTY911667Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Parking Brake Lever Travel

      5 to 8 notches at 200 N (20 kgf, 45.0 lbf)

      If the parking brake lever travel is not as specified, adjust the parking brake lever travel.

  2. REMOVE REAR WHEEL 

    Refer to REMOVAL [09/2022 - ]

  3. REMOVE DISK WHEEL SPACER 

    Refer to PROCEDURE - Step 10

  4. ADJUST PARKING BRAKE SHOE CLEARANCE 
    1. Temporarily install the hub nuts.

      HINT: 

      Secure the rear disc with the hub nuts.

    2. Remove the parking brake shoe adjusting hole plug.
    3. Turn the parking brake shoe adjuster and expand the shoes until the rear disc locks.
      GTY1024151Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Expand
      Contract
    4. Turn and contract the parking brake shoe adjuster until the rear disc can rotate smoothly.

      Standard

      Returns 8 notches

    5. Check whether the parking brake drags or not.
    6. Install the parking brake shoe adjusting hole plug.
    7. Remove the hub nuts.
  5. ADJUST PARKING BRAKE LEVER TRAVEL 
    1. Remove the parking brake hole cover sub-assembly.

      Refer to PROCEDURE - Step 8 [11/2022 - 09/2024] , or refer to PROCEDURE - Step 10 [09/2024 - ]

    2. Release the parking brake lever lock and return it to its off position.
    3. Loosen the No. 1 wire adjusting nut to completely release the parking brake cable as shown in the illustration.

      Parking Brake Lever Travel

      5 to 8 notches at 200 N (20 kgf, 45.0 lbf)

      GTY1111601Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 No. 1 Wire Adjusting Nut
      NOTE:

      Do not remove the No. 1 wire adjusting nut.

    4. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
    5. Check that the parking brake does not drag.
    6. Install the parking brake hole cover sub-assembly.

      Refer to PROCEDURE - Step 5 [11/2022 - 09/2024] , or refer to PROCEDURE - Step 5 [09/2024 - ]

  6. INSTALL DISK WHEEL SPACER 

    Refer to PROCEDURE - Step 11

  7. INSTALL REAR WHEEL 

    Refer to INSTALLATION [09/2022 - ]

  8. INSPECT BRAKE WARNING LIGHT 
    1. When operating the parking brake lever, check that the brake warning light illuminates.

      Standard

      The brake warning light always illuminates at the first click.