Installation [03/2017 - 06/2017]: Procedure

1. Temporarily install the rear suspension arm bracket to the rear trailing arm assembly with the bolt and nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   Insert the bolt from the inside of the vehicle.

2. Position the rear trailing arm assembly as shown in the illustration.

   Reference Length (A)

   120 mm (4.72 in.)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Upper Surface of Rear Suspension Arm Bracket

3. Fully tighten the nut.

   Torque: 120 N*m (1224 kgf*cm, 89 ft.*lbf) 

1. Engage the 4 claws and install the rear suspension arm cover.

1. Using a transmission jack and a wooden block, support the rear No. 2 suspension arm assembly.
   NOTE:

   • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
   • Make sure to perform this operation with the vehicle kept as low as possible.
2. Install the rear trailing arm assembly to the vehicle with the 4 bolts.

   Torque: 90 N*m (918 kgf*cm, 66 ft.*lbf) 

3. Install the rear trailing arm assembly to the rear axle carrier sub-assembly with the 2 bolts.

   Torque: 135 N*m (1377 kgf*cm, 100 ft.*lbf) 

1. Install the skid control sensor wire to the rear trailing arm assembly with the bolt.

   Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf) 

2. Engage the 2 clamps.

1. Install the No. 3 parking brake cable assembly to the rear trailing arm assembly with the nut.

   Torque: 15.5 N*m (158 kgf*cm, 11 ft.*lbf) 

See step  5

See step  9

See step  8

Refer to PROCEDURE - Step 1

Refer to ADJUSTMENT [03/2017 - 06/2017]