Inspection [03/2017 - ]: Procedure
- INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH
*a Component without harness connected
(Rear Seat Inner with Center Belt Assembly RH)- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 5 - 4 Rear RH seat belt unfastened Below 1 Ω Rear RH seat belt fastened 10 kΩ or higher If the result is not as specified, replace the rear seat inner with center belt assembly RH.
- Measure the resistance according to the value(s) in the table below.