LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry TRD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt - Service Information (Except Hybrid) >> Front Seat Outer Belt Assembly With Pre-TENSIONER >> Removal [10/2020 - ] >> Procedure

Removal [10/2020 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [03/2020 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    For A25A-FKS:

    Refer to PROCEDURE - Step 2

    For 2GR-FKS:

    Refer to PROCEDURE - Step 2

    WARNING:
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    • If an airbag deploys for any reason, it may cause a serious injury.
    GTY684647Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FRONT DOOR SCUFF PLATE 

    Refer to PROCEDURE - Step 5 [10/2020 - 08/2021] , or refer to PROCEDURE - Step 5 [08/2021 - ]

  4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP 
    1. Disconnect the front door opening trim weatherstrip.
  5. REMOVE REAR DOOR SCUFF PLATE 

    Refer to PROCEDURE - Step 9 [10/2020 - 08/2021] , or refer to PROCEDURE - Step 9 [08/2021 - ]

  6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP 
    1. Disconnect the rear door opening trim weatherstrip.
  7. REMOVE LAP BELT OUTER ANCHOR COVER 
    1. Disengage the 3 claws to remove the lap belt outer anchor cover.
      GTY753472Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY 
    1. Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.
      GTY753467Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE LOWER CENTER PILLAR GARNISH 

    Refer to PROCEDURE - Step 13 [10/2020 - 08/2021] , or refer to PROCEDURE - Step 13 [08/2021 - ]

  10. REMOVE UPPER CENTER PILLAR GARNISH 

    Refer to PROCEDURE - Step 14 [10/2020 - 08/2021] , or refer to PROCEDURE - Step 14 [08/2021 - ]

  11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY 
    1. Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
      GTY753469Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.
      GTY767440Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Locking Button
      *c Release

      HINT: 

      Tape the screwdriver tip before use.

    3. Remove the 2 bolts.
      GTY753363Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the 2 guides to remove the front seat outer belt assembly.
  12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY 
    1. Remove the 2 bolts.
      GTY753468Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guide to remove the front shoulder belt anchor adjuster assembly.
scientia non olet · About LEMON Manuals