Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during child restraint seat tether anchor bracket removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Perform steering sensor zero point calibration | Lane departure alert system (w/ Steering Control) | Refer to INITIALIZATION [03/2017 - 10/2020] |
| Pre-collision system | |||
| Intelligent clearance sonar system* | |||
| Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [03/2017 - ] | |
| Panoramic view monitor system | Refer to INITIALIZATION [06/2017 - 10/2020] |
*: When performing learning using the Techstream.
WARNING:
- Be sure to read Precaution thoroughly before servicing.
Refer to PRECAUTION [06/2017 - 09/2019]
- Wear protective gloves. Sharp areas on the parts may injure your hands.