Removal [10/2020 - ]: Procedure

RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
Refer to PROCEDURE - Step 1
REMOVE V-RIBBED BELT
Refer to REMOVAL [03/2017 - ]
REMOVE COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 1
REMOVE INLET AIR CLEANER ASSEMBLY
Refer to PROCEDURE - Step 21 [10/2020 - 08/2022] , or refer to PROCEDURE - Step 21 [08/2022 - ]
DISCONNECT NO. 5 WATER BY-PASS HOSE
Refer to PROCEDURE - Step 17

DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE SUB-ASSEMBLY

Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose sub-assembly from the compressor assembly with pulley.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the O-ring from the No. 1 cooler refrigerant discharge hose sub-assembly.
NOTE:
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

DISCONNECT SUCTION HOSE SUB-ASSEMBLY

Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with pulley.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the O-ring from the suction hose sub-assembly.
NOTE:
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

REMOVE COMPRESSOR ASSEMBLY WITH PULLEY

Disconnect the connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disconnect the connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

For Type A:

Remove the 2 bolts and 2 nuts.

	Bolt
	Nut

Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor assembly with pulley.

For Type B:

Remove the 4 bolts and compressor assembly with pulley.