Removal [03/2020 - 10/2020]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
Refer to REMOVAL [03/2020 - 10/2020]
- REMOVE PROPELLER SHAFT HEAT INSULATOR
Refer to PROCEDURE - Step 19
- REMOVE NO. 1 PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY
- Remove the 2 bolts and No. 1 propeller shaft heat insulator bracket sub-assembly from the transfer assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE REAR ENGINE MOUNTING BRACKET SUB-ASSEMBLY
Refer to PROCEDURE - Step 20
- REMOVE TRANSFER ASSEMBLY
- For Type A:
Remove the 6 nuts, 2 bolts and transfer assembly from the automatic transaxle assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
For Type B:
Remove the 8 nuts and transfer assembly from the automatic transaxle assembly.