Installation [10/2020 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL TRANSFER ASSEMBLY
- Using SST and a 17 mm union nut wrench, install the transfer assembly to the automatic transaxle assembly with the 8 nuts.
*a 17 mm Union Nut Wrench *b Torque Wrench Fulcrum Length - SST: 09961-00950
Specified tightening torque
Torque: 68.6 N*m (700 kgf*cm, 51 ft.*lbf)
HINT:
- Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Refer to PRECAUTION [03/2020 - ]
- When using a 17 mm union nut wrench (fulcrum length of 30 mm (1.18 in.)) + SST (fulcrum length of 150 mm (5.91 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 40.2 N*m (410 kgf*cm, 30 ft.*lbf)
- Using SST and a 17 mm union nut wrench, install the transfer assembly to the automatic transaxle assembly with the 8 nuts.
- INSTALL REAR ENGINE MOUNTING BRACKET SUB-ASSEMBLY
Refer to PROCEDURE - Step 12
- INSTALL NO. 1 PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY
- Install the No. 1 propeller shaft heat insulator bracket sub-assembly to the transfer assembly with the 2 bolts.
Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf)
- Install the No. 1 propeller shaft heat insulator bracket sub-assembly to the transfer assembly with the 2 bolts.
- INSTALL PROPELLER SHAFT HEAT INSULATOR
Refer to PROCEDURE - Step 13
- INSTALL AUTOMATIC TRANSAXLE ASSEMBLY
Refer to INSTALLATION [10/2020 - ]