Installation [03/2017 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL STARTER ASSEMBLY
1. Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.
  Torque: 46 N*m (469 kgf*cm, 34 ft.*lbf)
2. Connect the No. 2 engine wire to terminal 30 with the nut.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
3. Close the terminal cap.
4. Connect the starter assembly connector.

INSTALL FLYWHEEL HOUSING SIDE COVER

Align the protrusion with the cylinder block sub-assembly and engage the claw as shown in the illustration to install the flywheel housing side cover.

NOTE:

Make sure the claw makes a click sound, indicating that it fits tightly.
Replace the flywheel housing side cover with a new one if the claw does not fit tightly or is deformed.

INSTALL FRONT ENGINE MOUNTING INSULATOR
Refer to INSTALLATION [03/2017 - 03/2020] , or refer to INSTALLATION [03/2020 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2 [03/2017 - 08/2018] , or refer to PROCEDURE - Step 2 [08/2018 - ]