LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry TRD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical System (A25A-FKS) - Service Information (2 Of 5) (Except Hybrid)) >> Rear Crankshaft Oil Seal >> Removal [08/2022 - ] >> Procedure

Removal [08/2022 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY 
  2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY 
    1. Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.
      NOTE:
      • Using height adjustment attachments and plate lift attachments, keep the engine assembly level.
      • To prevent the No. 2 oil pan sub-assembly from deforming, do not place any attachments under the No. 2 oil pan sub-assembly of the engine assembly.
      • Using an engine sling device and engine lift, secure the engine assembly before servicing.
    2. Using SST, hold the crankshaft pulley assembly.
      GTY749031Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09213-54015 
      • SST: 09330-00021 
    3. Remove the 8 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly.
      GTY756897Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE NO. 1 CRANKSHAFT POSITION SENSOR PLATE 
    1. Type A:
      1. Remove the No. 1 crankshaft position sensor plate.
        GTY761088Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Type B:
      1. Remove the No. 1 crankshaft position sensor plate.
        GTY947951Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE REAR ENGINE OIL SEAL 
    1. Using a knife, cut off the lip of the rear engine oil seal.
      GTY752885Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Cut Position
    2. Using a screwdriver, pry out the rear engine oil seal.
      NOTE:

      Do not damage the surface of the rear engine oil seal press fit hole or the crankshaft.

      HINT: 

      Tape the screwdriver tip before use.

scientia non olet · About LEMON Manuals