LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry TRD >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System (2GR-FKS) - Service Information (Except Hybrid) >> Water Pump >> Removal [08/2018 - 10/2020] >> Procedure

Removal [08/2018 - 10/2020]: Procedure

  1. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 

    Refer to REMOVAL [08/2018 - 10/2020] 

  2. REMOVE V-RIBBED BELT 

    Refer to REMOVAL [06/2017 - ]

  3. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY 
    1. Remove the bolt and No. 2 idler pulley sub-assembly.
      GTY722079Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE WATER PUMP PULLEY 
    1. Using a screwdriver or equivalent with its tip wrapped in protective tape, hold the water pump pulley.
      GTY948837Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Hold
      *c Turn
    2. Remove the 4 bolts and water pump pulley.
  5. REMOVE ENGINE WATER PUMP ASSEMBLY 
    1. Remove the 15 bolts, engine water pump assembly and water pump gasket.
      GTY768488Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals