Customize Parameters [03/2017 - ]
- CUSTOMIZE METER / GAUGE SYSTEM NOTE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
HINT:
The following items can be customized.
- Customizing with the Techstream
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Customize Setting / Warning or Display.
- Select the setting by referring to the table below.
Warning
Tester Display Description Default Setting ECU Flasher Sound Volume Adjust Function to change the flasher sound volume Medium $02:Large, $00:Medium, $01:Small Combination meter assembly Suggestion Service Function Function to change the suggestion service display setting ON 00:OFF, 01:Only Parked, 11:ON Main body ECU (Multiplex network body ECU) Display
Tester Display Description Default Setting ECU ODO Display Time After IG OFF Adjust Function to change the ODO display time after the ignition switch is turned off 30s $00:30s, $01:60s, $02:600s, $03:OFF Combination meter assembly ECO Drive Indicator Zone Display Function (Meter) Function to enable/disable the eco driving indicator zone ON $00:OFF, $01:ON Combination meter assembly
- Customizing with the multi-display
- Turn the ignition switch to ON.
- Enter the following menus: MENU / Setup / Vehicle / Vehicle Customization / Convenience Services.
- Select the setting by referring to the table below.
Display Default Content Setting Relevant ECU Convenience Services On Function to change the suggestion service display setting On, On During, Off Main body ECU (Multiplex network body ECU)