Inspection [03/2020 - ]: Procedure
- INSPECT REAR DRIVE SHAFT ASSEMBLY
- Check that there is no excessive play in the radial direction of the outboard joint.
- Check that the inboard joint slides smoothly in the thrust direction.
- Check that there is no excessive play in the radial direction of the inboard joint.
- Check the boots for damage.
- Check whether the drive shaft dimension (A) is within specification.
Length (A)
749.1 to 759.1 mm (2.46 to 2.49 ft.)
NOTE:Keep the drive shaft assembly level during inspection.
If the boots are stretched or contracted, correct them.
- Check that there is no excessive play in the radial direction of the outboard joint.