LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry TRD >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Drive Shaft / Propeller Shaft - Service Information (Except Hybrid) >> FRONT DRIVE SHAFT ASSEMBLY (for A25A-FKS) >> Inspection [06/2017 - 09/2019] >> Procedure

Inspection [06/2017 - 09/2019]: Procedure

  1. INSPECT FRONT DRIVE SHAFT ASSEMBLY 
    1. Check that there is no excessive play in the radial direction of the outboard joint.
      GTY223263Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check that the inboard joint slides smoothly in the thrust direction.
    3. Check that there is no excessive play in the radial direction of the inboard joint.
    4. Check the boots for damage.
    5. Check whether the drive shaft dimension (A) and (B) are within specification.
      GTY752753Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A For LH Side
      *B For RH Side
      NOTE:

      Keep the drive shaft assembly level during inspection.

      1. For TMC Made:

        Dimension (A)

        For LH Side 591.2 mm (1.94 ft.)
        For RH Side 915.0 mm (3.00 ft.)

        Dimension (B)

        For LH Side 88.2 mm (3.47 in.)
        For RH Side 96.8 to 97.8 mm (3.82 to 3.85 in.)
      2. For TMMK Made:

        Dimension (A)

        For LH Side 590.4 mm (1.94 ft.)
        For RH Side 916.5 mm (3.01 ft.)

        Dimension (B)

        For LH Side 87.9 to 88.5 mm (3.47 to 3.48 in.)
        For RH Side 97.3 to 98.3 mm (3.84 to 3.87 in.)
scientia non olet · About LEMON Manuals