Caution / Notice / Hint

NOTE:

Inspect the fuses for circuits related to this system before performing the following procedure.
After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and system information memorization.
Refer to CALIBRATION [10/2020 - 08/2021] , or refer to CALIBRATION [08/2021 - ]

HINT:

When DTC P0571-11, P0571-12 and/or P0571-13 are output together with DTC C1380-7F, inspect and repair the trouble areas indicated by DTC P0571-11, P0571-12 and/or P0571-13 first.

P0571-11: Refer to DTC P0571-11: Brake Switch "A" Circuit Short to Ground [10/2020 - 08/2021] , or refer to DTC P0571-11: Brake Switch "A" Circuit Short to Ground [08/2021 - ]

P0571-12: Refer to DTC P0571-12: Brake Switch "A" Circuit Short to Battery [10/2020 - 08/2021] , or refer to DTC P0571-12: Brake Switch "A" Circuit Short to Battery [08/2021 - ]

P0571-13: Refer to DTC P0571-13: Brake Switch "A" Circuit Open [10/2020 - 08/2021] , or refer to DTC P0571-13: Brake Switch "A" Circuit Open [08/2021 - ]