Removal [06/2017 - ]: Procedure

Refer to PRECAUTION [06/2017 - ]

Refer to PROCEDURE - Step 1

Refer to TEST MODE PROCEDURE [06/2017 - 10/2020] , or refer to REAR BRAKE PAD REPLACEMENT MODE [10/2020 - ]

Refer to PROCEDURE - Step 4

WARNING:

• Be careful not to get pinched by the rear disc brake cylinder assembly or other parts when removing the rear disc brake pads.
• After lifting up the rear disc brake cylinder assembly, secure it in place before performing any work on it.
• The rear disc brake cylinder assembly could fall, pinching hands or fingers and causing injury.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Hold the rear No. 1 disc brake cylinder slide pin and remove the bolt.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Hold
   *b	Turn

2. Pull the rear disc brake cylinder assembly upward.
3. Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the rear No. 2 disc brake anti-squeal shim from the rear disc brake pad (inside).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Rear No. 1 Disc Brake Anti-squeal Shim
   *2	Rear No. 2 Disc Brake Anti-squeal Shim
   *3	Rear Disc Brake Anti-squeal Shim
   *4	Rear Disc Brake Pad Wear Indicator Plate

2. Remove the rear No. 1 disc brake anti-squeal shim from the rear disc brake pad (inside).
3. Remove the rear disc brake anti-squeal shim from the rear disc brake pad (outside).
4. Remove the rear disc brake pad wear indicator plate from each rear disc brake pad.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002