LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry TRD >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Panels / Trim - Service Information (1 Of 2) (Except Hybrid) >> Rear Bumper >> Removal [03/2017 - 06/2017] >> Procedure

Removal [03/2017 - 06/2017]: Procedure

  1. REMOVE REAR COMBINATION LIGHT COVER LH 

    Refer to PROCEDURE - Step 8

  2. REMOVE REAR COMBINATION LIGHT COVER RH 

    HINT: 

    Use the same procedure as for the LH side.

  3. REMOVE REAR BUMPER ASSEMBLY 
    1. Apply protective tape around the rear bumper assembly as shown in the illustration.
      GTY741381Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
    2. Remove the 2 screws.
      GTY753162Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the clip.
      GTY753167Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use the same procedure for the RH side and LH side.

    4. for Single Type:
      GTY764230Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 9 clips.
    5. for Dual Type:
      GTY762067Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 8 clips.
    6. Disengage the 6 claws as shown in the illustration.
      GTY742023Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction

      HINT: 

      Use the same procedure for the RH side and LH side.

    7. Disengage the 4 claws and 2 guides to remove the rear bumper assembly as shown in the illustration.
      GTY759256Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
scientia non olet · About LEMON Manuals