Adjustment [03/2017 - 10/2020]: Procedure

INSPECT REAR DOOR

Check that the clearance measurements of areas a through k are within each standard range.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

STANDARD CLEARANCE

Area	Measurement	Area	Measurement
a	3.3 to 6.7 mm (0.130 to 0.264 in.)	b	1.2 to 5.2 mm (0.0472 to 0.205 in.)
c	3.3 to 6.7 mm (0.130 to 0.264 in.)	d	0.6 to 4.6 mm (0.0236 to 0.181 in.)
e	3.3 to 6.7 mm (0.130 to 0.264 in.)	f	0.6 to 4.6 mm (0.0236 to 0.181 in.)
g	2.3 to 5.3 mm (0.0906 to 0.209 in.)	h	5.3 mm (0.209 in.)
i	4.1 mm (0.161 in.)	j	0 mm (0 in.)
k	2.3 to 6.3 mm (0.0906 to 0.248 in.)	-	-

ADJUST REAR DOOR

NOTE:

Make sure to turn the ignition switch off before adjusting the door lock strikers.

Using SST, loosen the 4 hinge bolts on the vehicle body and adjust the door position.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Tighten the 4 hinge bolts on the vehicle body after adjustment.
Torque: 26 N*m (265 kgf*cm, 19 ft.*lbf)
Loosen the 4 hinge bolts on the door and adjust the door position.
Tighten the 4 hinge bolts on the door after adjustment.
Torque: 26 N*m (265 kgf*cm, 19 ft.*lbf)

Using a T40 "TORX" socket wrench, slightly loosen the 2 striker mounting screws.

Using a brass bar and a hammer, hit the striker to adjust its position.
Using a T40 "TORX" socket wrench, tighten the 2 striker mounting screws after adjustment.
Torque: 23 N*m (235 kgf*cm, 17 ft.*lbf)