LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry TRD >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Network Gateway Ecu - Service Information (Except Hybrid) >> Network Gateway Ecu >> Removal [03/2017 - 06/2017] >> Procedure

Removal [03/2017 - 06/2017]: Procedure

  1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY 

    Refer to REMOVAL [03/2017 - 06/2017]

  2. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 34

  3. REMOVE ECU INTEGRATION BOX RH (w/ Smart Key System) 
    1. Disconnect each connector.
    2. Disengage the 2 clamps.
      GTY773920Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt, nut and ECU integration box RH.
  4. REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) (w/ Smart Key System) 
    1. Disengage the 2 claws and remove the central gateway ECU (network gateway ECU).
      GTY763414Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • If the ECU integration box is deformed or damaged, replace it.
      • Do not bend the 2 claws more than necessary.
  5. REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) (w/o Smart Key System) 
    1. Disconnect the central gateway ECU (network gateway ECU) connector.
      GTY763411Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the clamp.
    3. Remove the nut and central gateway ECU (network gateway ECU).
      GTY765011Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals