| Parking Assist ECU Communication Stop Mode |
Any of the following conditions are met:
- Communication stop for "Panoramic View Monitor / Circumference Monitoring Camera Control Module" is indicated on the "Communication Bus Check" screen of the Techstream.
Refer to PROBLEM SYMPTOMS TABLE [10/2020 - ]
- Communication stop history for "Panoramic View Monitor / Circumference Monitoring Camera Control Module" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Panoramic View Monitor / Circumference Monitoring Camera Control Module" is 6 or more.)
Refer to PROBLEM SYMPTOMS TABLE [10/2020 - ]
- Communication system DTCs (DTCs that start with U) that correspond to "Parking Assist ECU Communication Stop Mode" in "DTC Combination Table" are output.
Refer to DTC COMBINATION TABLE [10/2020 - 08/2021]
, or refer to DTC COMBINATION TABLE [08/2021 - ]
|
- Television camera controller branch line or connector
- Power source circuit of television camera controller
- Television camera controller ground circuit
- Television camera controller
|