Removal [06/2017 - 10/2020]: Procedure
- REMOVE BATTERY
Refer to REMOVAL [06/2017 - 08/2018] , or refer to REMOVAL [08/2018 - 10/2020]
- REMOVE ECM
Refer to REMOVAL [06/2017 - 03/2020] , or refer to REMOVAL [03/2020 - 10/2020]
- REMOVE BATTERY CLAMP SUB-ASSEMBLY
Refer to PROCEDURE - Step 24 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 24 [08/2018 - 09/2019] , or refer to PROCEDURE - Step 24 [09/2019 - 03/2020] , or refer to PROCEDURE - Step 25 [03/2020 - 10/2020]
- REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
Refer to REMOVAL [06/2017 - 03/2020] , or refer to REMOVAL [03/2020 - ]
- REMOVE FRONT LOWER NO. 1 FLOOR HEAT INSULATOR
- REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY
Refer to REMOVAL [03/2017 - ]
- REMOVE NO. 1 CONSOLE BOX DUCT (for Dual Type)
- REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
- While disengaging the clip as shown in the illustration, disconnect the transmission control cable assembly from the transmission control shaft lever together with the clip.
*a Clip *b 45° to 60° - Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
- Remove the 2 nuts and disconnect the transmission control cable assembly from the vehicle body.
- Remove the 2 nuts and then remove the transmission control cable assembly from the vehicle body.
- While disengaging the clip as shown in the illustration, disconnect the transmission control cable assembly from the transmission control shaft lever together with the clip.