DTC C2176-76: Receiver Error [03/2017 - 09/2019]: Procedure

1. Clear the DTCs.

   Chassis > Tire Pressure Monitor > Clear DTCs 

2. Turn the ignition switch off.
3. Turn the ignition switch to ON and check for DTCs.

   Chassis > Tire Pressure Monitor > Trouble Codes 

   OK

   DTC C2176/76 is not output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END 

Result: 

NG 

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER. Refer to  REMOVAL [03/2017 - 06/2017]  , or refer to  REMOVAL [06/2017 - 09/2019]